▣ PRODUCT

​

• Intercure 200 (Rapid Recoat Epoxy)

​

​

▣  PRODUCT DESCRIPTION

 

• A two component epoxy zinc phosphate / micaceous iron oxide primer, formulated on proprietary polymer technology, which provides rapid cure and overcoating even under low temperature conditions.

• A high solids, low VOC product.

​

​

▣ INTENDED USES

​

• As a primer for steelwork intended for use in a wide range of aggressive environments, including offshore, chemical and petrochemical plants, industrial buildings, pulp and paper mills, power plants and bridges.

• Suitable for overcoating within 3 hours in most climatic conditions hence speeding up production and throughput in fabrication shops.

• Can also be used on site as a rapid curing, maintenance coating.

 

​

▣ PRACTICAL INFORMATION FOR INTERCURE 200

​​

• ​Color : Limited colour range available

• Volume Solids : 67%

• Typical Thickness : 75-100 microns (3-4 mils) dry equivalent to 112-149 microns (4.5-6 mils) wet

• Method of Application : Airless Spray, Air Spray, Brush, Roller

​

​

▣ Drying Time

​

• Base Temperature : 77°F (25°C)

• Touch Dry : 20 minutes

• Hard Dry : 2 hours

• Overcoating Interval with recommended topcoats

       - ​Minimum : 1 hour

       - Maximum : Extended

​

​

▣ SURFACE PREPARATION

 

• Oil or grease should be removed in accordance with SSPC-SP1 solvent cleaning.

​

​

▣ APPLICATION

​

• Mix Ratio : 3 part(s) : 1 part(s) by volume

​

• Airless Spray - Recommended

      : Tip Range 0.43-0.53 mm (17-21 thou)
      : Total output fluid pressure at spray tip not less than

        176kg/cm² (2503 p.s.i.)

​

• Air Spray (Pressure Pot) - Recommended

      : Gun DeVilbiss MBC or JGA
      : Air Cap 704 or 765
      : Fluid Tip E

​

• Brush : Suitable - Small areas only

 

• Roller : Suitable - Small areas only

 

• Thinner : International GTA220

                    (International GTA415)

​

​

▣ SYSTEMS COMPATIBILITY

​

• Intercure 200 will normally be applied to suitably prepared steel, e.g. blast cleaned. However, if necessary, application over prefabrication blast primers can be performed. Consult International Protective Coatings for further details.

​

• The following primers are recommended for Intercure 200:

       : Interzinc 22 * (mist coat or tie coat may be required)

​

• The following topcoats/intermediates are recommended for Intercure 200:

       Intercure 420           Interseal 670HS

       Interfine 979            Interthane 990

       Intergard 475HS      Interzone 1000

       Intergard 740           Interzone 954

​

​

▣ STORAGE

​

• 12 months minimum at 25°C (77°F).

• Subject to re-inspection thereafter. Store in dry, shaded conditions away from sources of heat and ignition.