▣  PRODUCT

 

• Intergard 475HS (Epoxy)

 

​

▣ PRODUCT DESCRIPTION

 

• A low VOC, high solids, high build, two component epoxy coating. Available with conventional pigmentation, or alternatively
  can be pigmented with micaceous iron oxide to provide enhanced overcoating properties.

​​

 

▣  INTENDED USES

​

• For use as a high build epoxy coating to improve barrier protection for a range of anti-corrosive coating systems in a wide range of environments including offshore structures, petrochemical plants, pulp and paper mills and bridges.

• Suitable for use in both maintenance and new construction situations as part of an anti-corrosive coating system. 

• The micaceous iron oxide variant improves long term overcoating properties, better facilitating application in the fabrication shop, prior to shipping, with final overcoating on site.

 

​

▣ PRACTICAL INFORMATION FOR INTERGARD 475HS

​​

• ​Color : Light gray MIO and a selected range of colors

• Volume Solids : 80%

• Typical Thickness : 4-8 mils (100-200 microns) dry equivalent to 5-10 mils (125-250 microns) wet

• Method of Application : Airless Spray, Air Spray, Brush, Roller

​

​

▣ Drying Time

​

• Base Temperature : 77°F (25°C)

• Touch Dry : 60 minutes

• Hard Dry : 5 hours

• Overcoating Interval with recommended topcoats

       - ​Minimum : 5 hours

       - Maximum : Extended

​

​

▣ APPLICATION

​

• Mix Ratio : 3 part(s) : 1 part(s) by volume

​

• Airless Spray - Recommended

      : Tip Range 21-25 thou (0.53-0.63 mm)
      : Total output fluid pressure at spray tip not less than

        2702 psi (190 kg/cm²)

​

• Air Spray (Pressure Pot) - Recommended

      : Gun DeVilbiss MBC or JGA
      : Air Cap 704 or 765
      : Fluid Tip E

​

• Brush : Suitable 

 

• Roller : Suitable 

 

• Thinner : International GTA007

 

​

▣  SYSTEMS COMPATIBILITY

 

• Intergard 475HS is designed for use over correctly primed steel. Suitable primers are:

       Intercure 200         Interzinc 52

       Intergard 251         Interzinc 315

       Intergard 269         

       Interzinc 22 (mist coat or tie coat recommended)

       Interzinc 2280 (mist coat or tie coat recommended)

​

• Suitable topcoats are:

       Intergard 740         Interfine 629HS

       Interthane 990       Intergard 475HS

 

​

▣ STORAGE

​

• 12 months minimum at 25°C (77°F).

• Subject to re-inspection thereafter. Store in dry, shaded conditions away from sources of heat and ignition. Elevated storage
  temperatures reduce shelf life.