▣ PRODUCT

 

• Intergard 345 (Epoxy)

 

 

▣  PRODUCT DESCRIPTION

 

• A two component, low VOC, high solids, fast curing epoxy primer/finish containing zinc phosphate anti-corrosive pigmentation.

 

​

▣  INTENDED USES

 

• Suitable for use as a one or two coat primer/finish coating or as an intermediate over recommended anti-corrosive primers.

• Intergard 345 provides a combination of anti-corrosive barrier protection, chemical fume and spillage resistance, along with good abrasion resistance. Ideal for use in moderately corrosive environments and where fast drying/rapid recoating is desired.

 

 

▣  PRACTICAL INFORMATION FOR INTERGARD 345

​

• Color : Wide range via the Chromascan system

• Volume Solids : 70%

• Typical Thickness : 4-6 mils (100-150 microns) dry equivalent to 5.7-8.6 mils (143-214 microns) wet

• Method of Application : Airless Spray, Air Spray, Brush, Roller

​

​

▣ Drying Time

​

• Base Temperature : 77°F (25°C)

• Touch Dry : 60 minutes

• Hard Dry : 2.5 hours

• Overcoating Interval with recommended topcoats

       - ​Minimum : 2.5 hours

       - Maximum : Extended

​

​

▣ SURFACE PREPARATION

 

• Oil or grease should be removed in accordance with SSPC-SP1 solvent cleaning.

​

​

▣ APPLICATION

​

• Mix Ratio : 4 part(s) : 1 part(s) by volume

​​

• Airless Spray - Recommended

      : Tip Range 0.43-0.53 mm (17-21 thou)
      : Total output fluid pressure at spray tip not less than

        176kg/cm² (2503 p.s.i.)

​​​

• Air Spray (Pressure Pot) - Recommended

      : Gun DeVilbiss MBC or JGA
      : Air Cap 704 or 765
      : Fluid Tip E

​​​

• Brush : Suitable - Small areas only

 

• Roller : Suitable - Small areas only

 

• Thinner : International GTA220

                    (International GTA415)

​

​​​​

▣ SYSTEMS COMPATIBILITY

 

• Intergard 345 is normally applied directly to blast cleaned steel, however, it can also be applied directly over the following primers:

       Intercure 200HS      Intercure 200

       Intergard 251           Intergard 269

       Intergard 345           Interzinc 52

       Interzinc 315

​

• The following topcoats are recommended :

       Interfine 629HS        Intergard 740

       Interthane 870          Interthane 990

​

​

▣ STORAGE

​

• 18 months minimum at 25°C (77°F).

• Subject to re-inspection thereafter. Store in dry, shaded conditions away from sources of heat and ignition.