▣ PRODUCT

 

• Intercure 200HS (Rapid Recoat Epoxy)

​

​

▣ PRODUCT DESCRIPTION

 

• A two component, high solids, low VOC, epoxy zinc phosphate/micaceous iron oxide primer offering excellent barrier protection, low temperature cure and rapid overcoating properties.

​

​

▣ INTENDED USES

 

• As a primer for steelwork intended for use in a wide range of environmental conditions including offshore, chemical and petrochemical plants, industrial buildings, pulp and paper mills, power plants and bridges.

• Suitable for overcoating within 7 hours in most climatic conditions hence speeding up production and throughput in fabrication shops.

• Provides quick cure even at low temperatures often encountered in maintenance painting.

​

​

▣ PRACTICAL INFORMATION FOR INTERCURE 200HS

​

• Color : Sand, Grey, Red

• Volume Solids : 80%

• Typical Thickness : 6-8 mils (150-200 microns) dry equivalent to 7.5-10 mils (188-250 microns) wet

• Method of Application : Airless Spray, Air Spray, Brush, Roller

​

​

▣ Drying Time

​

• Base Temperature : 77°F (25°C)

• Touch Dry : 2 hours

• Hard Dry : 3 hours

• Overcoating Interval with recommended topcoats

       - ​Minimum : 3 hours

       - Maximum : Extended

​

​

▣ SURFACE PREPARATION

 

• Oil or grease should be removed in accordance with SSPC-SP1 solvent cleaning.

​

​

▣ APPLICATION

​

• Mix Ratio : 3 part(s) : 1 part(s) by volume

​​​

• Airless Spray - Recommended

      : Tip Range 0.45-0.58 mm (18-23 thou)
      : Total output fluid pressure at spray tip not less than

        170kg/cm² (2417 p.s.i.)

​​​

• Air Spray (Pressure Pot) - Recommended

      : Gun DeVilbiss MBC or JGA
      : Air Cap 704 or 765
      : Fluid Tip E

​​​

• Brush : Suitable - Small areas only

 

• Roller : Suitable - Small areas only

 

• Thinner : International GTA220

                    (International GTA415)

​

​

▣ SYSTEMS COMPATIBILITY

​

• Intercure 200HS will normally be applied to suitably prepared steel, e.g. blast cleaned. However, if necessary, application over prefabrication blast primers can be performed. Consult International Protective Coatings for further details.

​​

• Recommended topcoats/intermediates are:

       Intercure 420HS           Intercure 4500

       Interfine 629HS            Interfine 691

       Interfine 878                 Interfine 979

       Intergard 410                Intergard 345

       Intergard 475HS           Intergard 740

       Interseal 670HS           Interthane 870

       Interthane 990              Interzone 1000

​

​

▣ STORAGE

​

• ​12 months minimum at 25°C (77°F).

• Subject to re-inspection thereafter. Store in dry, shaded conditions away from sources of heat and ignition.